Skip to main content

Heavy-equipment parts · Hydraulic pumps · Rotary groups · Machinery

Hồ Chí Minh(+8428) 3898 2851

Topic

Diagnosis & repair

From symptom to cause to fix — HowTo guides mapped to real failure modes.

Articles in this topic (24)

Two hydraulic piston pumps, one yellow and one red tandem unit, seen from the shaft endDiagnosis & repair

Excavator sluggish when cold: 5 causes and fixes

An excavator that is sluggish at start-up but stronger once warm is almost always thick oil, the wrong grade, a clogged suction filter, or cavitation from early revving — not a failing pump. Here are 5 causes and the right fixes.

Nguyễn Văn Hùng15 min
An assortment of oil seals, cylinder seals and O-rings in several sizes, in black, blue, orange and yellowDiagnosis & repair

Bent hydraulic cylinder rod: 4 causes and how to check

A bent rod presses the seal lip off-centre and scores the tube, so oil weeps again right after a reseal. Four causes, the failure mechanism, and three ways to check straightness before you touch the seal kit.

Nguyễn Văn Hùng14 min
A group of construction-machinery filters: air, oil, fuel and hydraulic filter elements side by sideDiagnosis & repair

Foaming Hydraulic Oil: 7 Warning Signs to Fix Now

White foam on the oil tank usually signals a suction air leak or the wrong oil; this guide shows how to find the gap and fix it early.

Nguyễn Văn Hùng12 min
Construction-machinery engine parts: a turbocharger, two cooling fans and assorted small engine componentsDiagnosis & repair

Excavator black smoke: 8 causes and how to fix it

Read the smoke colour and narrow down excavator black smoke from air filter, fuel and injectors to a worn engine, and know when to head to the workshop.

Nguyễn Văn Hùng12 min
Two hydraulic piston pumps, one yellow and one red tandem unit, seen from the shaft endDiagnosis & repair

Excavator slow to build power: 8 causes and fixes

A field guide to diagnosing a slow-to-build excavator from oil, filters and the suction line to the pilot circuit and pump, cheapest-first.

Nguyễn Văn Hùng12 min
A group of construction-machinery filters: air, oil, fuel and hydraulic filter elements side by sideDiagnosis & repair

Excavator Overheating, Coolant Boiling: 8 Causes and Fixes

An excavator hot enough to boil its coolant usually points to a dirty radiator, low coolant, a stuck thermostat or a blown head gasket, with safe steps to narrow and fix it.

Nguyễn Văn Hùng12 min
Four views of a cast-iron excavator hydraulic-pump regulatorDiagnosis & repair

Excavator pilot pressure loss: 8 causes and fixes

Understand the pilot system, narrow the cause by symptom, and diagnose excavator pilot pressure loss from cheap to expensive before pulling the pump.

Nguyễn Văn Hùng12 min
An assortment of oil seals, cylinder seals and O-rings in several sizes, in black, blue, orange and yellowDiagnosis & repair

Hydraulic cylinder drift: 6 causes and how to fix it

Work out whether cylinder drift is from the seal, the valve or a scored rod, how to test them apart, and when to replace the seal or service the rod.

Nguyễn Văn Hùng12 min
Four hydraulic gear pumps: two blue-and-aluminium units, one black and one redDiagnosis & repair

Hydraulic pump noise: 6 sounds and how to diagnose

Listen and tell apart the sounds of a noisy hydraulic pump — whine, knock, rattle — to narrow the cause and know when to stop the machine.

Nguyễn Văn Hùng12 min