Hydraulic system
General seals & gaskets
General seals & gaskets — sealing parts for hydraulic pumps, motors and cylinders.

Quick answer
General seals & gaskets: what are they?
General seals and gaskets are the sealing parts used across the whole machine — head gaskets, cover gaskets, oil seals, O-rings and copper washers — not just in the hydraulics. They are identified by profile, size and material (NBR, Viton, composite or metal) rather than by eye. Viet Trung Hai matches and supplies individual seals and gaskets from your old sample or the part code across many machine makes.
- PET Seals · NOK · SKF distributor
- Nationwide delivery · HCMC warehouse
- Wholesale and retail
- Fitment confirmed before we quote
Beyond the hydraulic assemblies, a machine has dozens of points that must stay sealed: the cylinder head, valve cover, water pump, pipework, flanges and fittings. General seals and gaskets cover these. What matters at purchase is matching the exact profile and material, because the same diameter in a different cross-section or a different rubber compound will still leak. Viet Trung Hai matches against your old sample or the code printed on the part.
| Type | Typical location | Common material |
|---|---|---|
| Head gasket | Cylinder head, covers | Metal, composite |
| Oil seal | Shafts, pump necks | NBR rubber |
| O-ring | Fittings, flanges | NBR, Viton |
| Copper washer | Banjo bolts, unions | Copper |
| V-ring | Rotating shafts | Rubber |
Bring the old sample or read us the part code; for gasket sheet cut to size, tell us the machine so we pick the right thickness and material. Available in genuine and high-quality replacement grades.
Wear signs
When to replace the general seals & gaskets
- Oil leaking at shafts, pistons or joints
- Pressure loss, weak equipment
- Best replaced as a full kit at overhaul
- Dirt ingress causing rapid wear
Related part groups
All hydraulic seal partsFind it
Order the exact part
Pick whichever suits you — our team confirms fitment, then quotes.
By part number
Send the number stamped on the old part for the exact match.
By machine model
e.g. Komatsu PC200-8, Hitachi ZX200 — send the model to match.
By pump / motor series
e.g. K3V112, A8VO107 — when you know the pump code.
FAQ
Frequently asked questions
How do I identify the right gasket without a code?
Bring the old sample or a clear photo; we match by profile, diameter, cross-section and material, because the same diameter in a different section will still leak.
What is the difference between NBR and Viton?
Viton resists heat, oil and chemicals better, suiting hot spots; NBR is the common choice for ordinary hydraulic oil. Pick by where the part works.
Can I reuse copper washers?
Better not; a copper washer is crushed to seal and tends to leak once reused. Fit new ones each time you open a joint, especially on banjo bolts and unions.
Get a quote
Need the right part, fast?
Send your machine model and the part you need — we confirm fitment and quote.
- Pump code / plate
- Machine model
- Photo of the old part