Skip to main content

Heavy-equipment parts · Hydraulic pumps · Rotary groups · Machinery

Hồ Chí Minh(+8428) 3898 2851
Drive shaft – Rexroth A8VO107

Uchida/Rexroth · A8VO

Drive shaft – Rexroth A8VO107

New, correct codeOn requestA8VO107

Quick answer

The A8VO107 drive shaft transmits torque from the engine into the cylinder block of the Rexroth (Uchida) A8VO main pump on ~20-ton excavators.

Việt Trung Hải, the authorized JIC Hydraulics distributor, supplies genuine and JIC shafts cut to the code, fitting the original housing, with a fast quote.

Not sure of the code? Send a photo of the pump nameplate or your machine model and our technicians will check it before you order.

Part type
Drive shaft
Brand / pump line
Uchida/Rexroth · A8VO
Model code
A8VO107
Condition
New, correct code
Availability
On request

What the A8VO107 drive shaft fits

The drive shaft transmits torque from the engine into the cylinder block to spin the pump's rotary group. This is the shaft for the Rexroth (Uchida) A8VO107 main pump — an axial-piston pump used on ~20-ton excavators. Its splines must mesh cleanly and run true so the pump turns smoothly, without play.

When to replace

Worn, pitted or rolled splines cause slippage, noise and vibration under load. A scored seal journal leaks oil around the flange. A bent or cracked shaft weakens the pump and makes flow erratic — replace it before the damage spreads to the block and swash plate.

Genuine-quality parts

Việt Trung Hải is the authorized distributor for JIC Hydraulics, and the JIC A8VO107 shaft is machined on that code — right spline profile, right seal-journal diameter, proper heat treatment — so it goes into the pump housing you already have. Genuine shafts are stocked as well. Contact us for a fast quote.

Frequently asked questions

Which excavator does the A8VO107 drive shaft fit?

It is the drive shaft for the Rexroth (Uchida) A8VO107 axial-piston main pump used on ~20-ton excavators. Send the pump code and a photo of the old shaft so we match the correct spline profile.

How do I know the drive shaft needs replacing?

Worn or pitted splines cause noise and vibration under load, and a scored seal journal leaks oil at the flange. A bent or cracked shaft makes flow erratic — replace early to avoid damage spreading to the block.

Does a JIC A8VO107 shaft need any machining to fit?

No. The JIC shaft is cut to the A8VO107 code, with the spline count and journal tolerances on spec, so it drops into the original pump housing with no reaming or fitting. Việt Trung Hải is the authorized JIC Hydraulics distributor — contact us for advice and a fast quote.

Get a quote

Request a quote: Drive shaft – Rexroth A8VO107

This is a quote model, not a cart. Send your machine model or pump code and we confirm fitment and quote fast.

By sending this request you agree that Việt Trung Hải may use these details to contact you and quote, as set out in our Privacy policy.

Related parts

Technical handbook

Related guides